[DXLog.net - Support] Footswitch

9A5K 9a5k at 9a5k.com
Mon May 19 09:04:49 CEST 2014

Hi Vlad..

It is same as used with N1MM software..
So, here it goes:

Serial port footswitch information (using the 9 pin connector numbers)

Connect a 10k resistor between pin 6 and pin 7. Set DTR, pin 4 to "Always
On" and RTS, pin 7 to "Always Off". Connect the footswitch between pins 4
and pin 6.
The program action will be on footswitch closure. The footswitch wires can
not be referenced or connected to ground.

This is how I am using it too here. And works.
Of course, you need PTT pin configure on some of the interfaces..

Chris - 9A5K

On Mon, May 19, 2014 at 3:24 AM, SOUZKABEL <souzkabel at yandex.ru> wrote:

> Hello !
> Specify how to make the interface and the settings for connecting to the
> serial port footswitch. ?
> This feature is already working?
> My attempts were unsuccessful :(
> R9IR
> Vlad
> _______________________________________________
> Support mailing list
> Support at dxlog.net
> http://www.dxlog.net/mailman/listinfo/support

More information about the Support mailing list