[DXLog.net - Support] Footswitch
9a5k at 9a5k.com
Thu May 22 09:19:44 CEST 2014
Footswitch should be set to PTT at COM1.
COM5 should be fine.
Try to restart DXLog.net after you change the settings.
Also, you can check PTT status in Radio/Ant status window.
When PTT is activated, there should be green line visible on the screen.
Also, is there network enabled? If it is, is Interlock activated?
Can we get more info about the interface?
On Thu, May 22, 2014 at 7:47 AM, Sergey Dvadnenko <ua6aa at yahoo.com> wrote:
> Hi everyone!
> The same problem here also.
> That's what I do, step by step:
> 1. Com5 -> Enable-> Radio1->(DTR-CW, RTS-PTT) -> Check - works
> 2. COM1 -> Enable-> -- -> (DTR -Always ON, RTS - Always OFF,
> Footswitch -None)
> 3. Connect footswitch thrue the homemade interface to com1...checking
> Sergey UA6AA
> Hi Vlad.
> It works here without any problem.
> Usually, I made a mistake and forget about DTR Always ON setting at this
> port where footswitch is connected.
> If there will be a problem to start this, please send me your port
> configuration screen, so I can check it here.
> Chris - 9A5K
> On Mon, May 19, 2014 at 9:34 AM, Souzkabel <souzkabel at yandex.ru <http://www.dxlog.net/mailman/listinfo/support>> wrote:
> >* Hello Chris !
> >>* Thank you very much
> *>>>>* I tried to do the same
> *>>* I probably made a mistake
> *>>* I will try again and again :)
> *>>>* Vlad
> *>>* R9IR
> >* Hi Vlad..
> *>>* It is same as used with N1MM software..
> *>>* So, here it goes:
> >* Serial port footswitch information (using the 9 pin connector numbers)
> *>>>* Connect a 10k resistor between pin 6 and pin 7. Set DTR, pin 4 to "Always
> *>* On" and RTS, pin 7 to "Always Off". Connect the footswitch between pins 4
> *>* and pin 6.
> *>* The program action will be on footswitch closure. The footswitch wires can
> *>* not be referenced or connected to ground.
> >* This is how I am using it too here. And works.
> *>>* Of course, you need PTT pin configure on some of the interfaces..
> *>>>* 73,
> >* Chris - 9A5K
> >>* On Mon, May 19, 2014 at 3:24 AM, SOUZKABEL <souzkabel at yandex.ru <http://www.dxlog.net/mailman/listinfo/support>> wrote:
> *>>* Hello !
> *>* Specify how to make the interface and the settings for connecting to the
> *>* serial port footswitch. ?
> *>* This feature is already working?
> *>* My attempts were unsuccessful :(
> *>>* R9IR
> *>* Vlad
> *>* _______________________________________________
More information about the Support